[[José Luis Garcí]]

Cambios a realizar en la unidad UBAncos de Bancos

debe quedar de la siguiente manera:

Código Delphi [-]
procedure TFBancos.DSPrincipalDataChange(Sender: TObject; Field: TField);
//------------------------------------------------------------------------------
//******************************************************[ Datasorce change ]****
//------------------------------------------------------------------------------
begin
   if (not (DsPrincipal.DataSet.State in [dsEdit,dsInsert])) and (FBancos.Active) then
   begin
       Label12.Caption :=ceros(DBEdit5.Text,4)+'/'+ ceros(DBEdit6.Text,4)+'/'+ceros(DBEdit7.Text,2)+'/'+ceros(DBEdit8.Text,10);
   end;
end;

y

Código Delphi [-]
procedure TFBancos.DBEdit5Change(Sender: TObject);
//------------------------------------------------------------------------------
//********************************************************[ Change Dbedit5 ]****
// Comprueba el digíto de control
//------------------------------------------------------------------------------
begin
  TDBEdit(Sender).Text:=EditLogico(tedit(TDBEdit(Sender)), '0123456789');
  if (DBEdit5.Text<>'') and (DBEdit6.Text<>'') and (DBEdit8.Text<>'') and (FBancos.Active) then
  begin
    DBEdit7.Field.Value:=StrToInt( IntToStr(CalculaDC(ceros(DBEdit5.Text,4)+ ceros(DBEdit6.Text,4),ceros(DBEdit8.Text,10))));
  end;
   Label12.Caption :=ceros(DBEdit5.Text,4)+'/'+ ceros(DBEdit6.Text,4)+'/'+ceros(DBEdit7.Text,2)+'/'+ceros(DBEdit8.Text,10);
  if (Length(DBEdit5.Text)>=4) and (Sender=DBEdit5) then DBEdit6.SetFocus;
  if (Length(DBEdit6.Text)>=4) and (Sender=DBEdit6) then DBEdit8.SetFocus;
end;

Como podéis comprobar me faltaba en ambos casos and (FBancos.Active) para evitar que cargue datos sin estar activo